| Andes Workshop https://forum.andestech.com/ |
|
| multi-core debug in Andesight https://forum.andestech.com/viewtopic.php?f=6&t=959 |
Page 1 of 1 |
| Author: | jimmy [ Fri Jul 22, 2016 6:24 pm ] |
| Post subject: | multi-core debug in Andesight |
The way to automatically start ICEman: 1. Launch core0 project without disabling “Target Management Service". ICEman will be started by AndeSight. (auto run in port 9900) 2. Record the port no. of core1 in ICEman window. 3. Disable “Target Management Service" in core1 project and set Port no. to core1 port no.(9903) 4. Launch core1 project |
|
| Author: | jimmy [ Fri Jan 13, 2017 3:44 pm ] | |||
| Post subject: | Re: multi-core debug in Andesight | |||
How to setup core1 in Andesight ? core0: port 9900 -> burner (AICE) port 9901 -> telnet port 9902 -> GDB server port core1: port 9903 -> burner (AICE) port 9904 -> telnet port 9905 -> GDB server port ICEman connect to burner port. If port is occupied by other software, Andesight will use next port.
|
||||
| Page 1 of 1 | All times are UTC + 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|