AICE-MCU upgrade to version 1.7.7 instructions
Step 1. Download the upgrade package and decompress it.
Attachment:
AICE-MCU_v1.7.7_20130508.zip [124.86 KiB]
Downloaded 1713 times
Step 2. Connect the USB cable to your PC.
Attachment:
aice-mcu.jpg [ 32.27 KiB | Viewed 15461 times ]
Double-click to execute
"upgrade_aice_firmware.bat"Attachment:
1.jpg [ 30.26 KiB | Viewed 15461 times ]
It needs about 3.5 minutes
Attachment:
2.jpg [ 37.31 KiB | Viewed 15461 times ]
Step 3. After the completion of upgrade aice firmware, please disconnect and reconnect the USB cable to reset AICE-MCU.
Attachment:
3.jpg [ 51.35 KiB | Viewed 15461 times ]
Step 4. Double-click to execute
"upgrade_aice_fpga.bat"Attachment:
4.jpg [ 24.13 KiB | Viewed 15461 times ]
It takes about 6.5 minutes.
Attachment:
5.jpg [ 36.47 KiB | Viewed 15461 times ]
Step 5. After the completion of upgrade aice FPGA, please disconnect and reconnect the USB cable to reset AICE-MCU.
Attachment:
6.jpg [ 41.2 KiB | Viewed 15461 times ]
Step 6. Verify if the upgrade was successful.
Double-click to execute
"check_version.bat"As shown below, it is version 1.7.7 now.
Attachment:
7.jpg [ 51.58 KiB | Viewed 15461 times ]
Step 7. If the version is not 1.7.7, please repeat steps 2-6 once.
Step 8. If the version is not 1.7.7 yet, please contact Andes Service for assistance.
----------------------------------------------------------
These devices are also required to connect R6 on the adaptor for supporting 5-wire interface.Attachment:
r6.gif [ 133.15 KiB | Viewed 13011 times ]
Login
FAQ
Search
Members
