Andes Workshop
http://forum.andestech.com/

multi-core debug in Andesight
http://forum.andestech.com/viewtopic.php?f=6&t=959
Page 1 of 1

Author:  jimmy [ Fri Jul 22, 2016 6:24 pm ]
Post subject:  multi-core debug in Andesight

The way to automatically start ICEman:
1. Launch core0 project without disabling “Target Management Service". ICEman will be started by AndeSight. (auto run in port 9900)
2. Record the port no. of core1 in ICEman window.
3. Disable “Target Management Service" in core1 project and set Port no. to core1 port no.(9903)
4. Launch core1 project

Author:  jimmy [ Fri Jan 13, 2017 3:44 pm ]
Post subject:  Re: multi-core debug in Andesight

How to setup core1 in Andesight ?

core0: port 9900 -> burner (AICE) port
9901 -> telnet port
9902 -> GDB server port
core1: port 9903 -> burner (AICE) port
9904 -> telnet port
9905 -> GDB server port

ICEman connect to burner port.
If port is occupied by other software, Andesight will use next port.

Attachments:
2017-01-13_143806.png
2017-01-13_143806.png [ 86.21 KiB | Viewed 12311 times ]
2017-01-13_143411.png
2017-01-13_143411.png [ 92.29 KiB | Viewed 12311 times ]

Page 1 of 1 All times are UTC + 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/