Andes Workshop http://forum.andestech.com/ |
|
A Demo Code which show how to use fread For AndeSight http://forum.andestech.com/viewtopic.php?f=6&t=718 |
Page 1 of 1 |
Author: | HuJin [ Wed Jul 03, 2013 1:00 pm ] |
Post subject: | A Demo Code which show how to use fread For AndeSight |
This is a demo code about how to use fread. We will show the steps for how to run this demo in Andesight v200 STD. Step1: Download the attached file and put it somewhere. This is a project file which can be directly impoted in Andesight v200 STD. Attachment: Step2: Open Andesight v200 STD. Click “File” --》 “Import...”then import the project file. Attachment: Attachment: step3: Check the target board (or choose your target chip and toolchain). In this demo we use "ADP-AG101P-4GB-N1337-FPU" as target chip and "nds32le-elf-mculib-v3" as toolchain. Attachment: Step4: Compile the project and run it. The results of this demo code will show in Console View. Attachment: Attachment: Note: In this article, we assume that Andesight v200 STD's workspace is under $WORKPATH\Andestech\AndeSight200STD\ide_64\workspace or $WORKPATH\Andestech\AndeSight200STD\ide\workspace, otherwise the testbitmap.c in the demo project should be modified based on your enviroment or it can't run normally. |
Page 1 of 1 | All times are UTC + 8 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |