昨天安裝了Andesight v200 standard beta Linux版，
照installation guide就可以順利裝上去。
下面分享一下我的安裝過程。
cindy@apc047:~/workspace/AndeSight_v200_STD_beta_20120106-Linux/Linux/Disk1$ ls AndeSight_v2.0.0_STD_Installation_Guide_UM051_V1.0.pdf Startup.sh InstData cindy@apc047:~/workspace/AndeSight_v200_STD_beta_20120106-Linux/Linux/Disk1$ chmod +x Startup.sh cindy@apc047:~/workspace/AndeSight_v200_STD_beta_20120106-Linux/Linux/Disk1$ ./Startup.sh Preparing to install...
Extracting the JRE from the installer archive...
Unpacking the JRE...
Extracting the installation resources from the installer archive...
Configuring the installer for this system's environment...
Launching installer...
然後會出現視窗，依視窗指示安裝。
最後要依指示run 2個程式。
Attachment:
STD.gif [ 157.01 KiB | Viewed 8958 times ]
cindy@apc047:~/Andestech/AndeSight200STDbeta/ice$ sudo ./ICEman.sh [sudo] password for cindy:
Done!
cindy@apc047:~/Andestech/AndeSight200STDbeta/ice$ sudo ./change-udev-usb-mode.sh copy 50-udev-default.rules change libusb MODE=666 restart udev udev start/running, process 11213 cindy@apc047:~/Andestech/AndeSight200STDbeta/ice$