Andes Workshop http://forum.andestech.com/ |
|
AndeSight STD Quick Start Guide http://forum.andestech.com/viewtopic.php?f=6&t=1046 |
Page 1 of 1 |
Author: | Niraj Dengale [ Wed May 08, 2019 4:39 pm ] |
Post subject: | AndeSight STD Quick Start Guide |
Please follow the steps below to get started with AndeSight STD Installation ------------- 1. Double click setup.exe to install AndeSight from install directory. Attachment: 2. Follow the installer instructions to install AndeSight. In license type selection page, please choose "Activation code" to finish installation. Attachment: activation_method.jpg [ 54.04 KiB | Viewed 50252 times ] Product activation -------------------- 1. Double-click the desktop shortcut or the file “AndeSight.exe” under AndeSight_ROOT\ide to launch the AndeSight IDE. 2. A dialog pops out to remind you that no license is installed yet. Click the “Install now…” button to open activation window Attachment: 3. In the invoked dialog, enter a valid activation code received from Andes Technology Corporation. Then, click “Deploy Activation code” or the “OK” Button. Attachment: license_code.jpg [ 71.79 KiB | Viewed 50252 times ] 4. A dialog box containing license information pops out next. Click “OK” to complete the license activation Attachment: Run first project ------------------- 1. Find the Andes Project Creator view on the launched AndeSight IDE. Select a connection configuration and project language. Then, expand a group in the Chip Profile section and double-click the desired chip profile. Attachment: proj_creator.jpg [ 13.14 KiB | Viewed 50252 times ] Attachment: 2. A dialog box opens. Enter a project name and select "Hello World ANSI C Project". Then, click the “Finish” button. Attachment: proj_config.jpg [ 100.2 KiB | Viewed 50252 times ] 3. Select the created project folder in the Project Explorer view and click "Build" icon on the AndeSight toolbar to compile the program, as shown in below picture. Attachment: 4. Check the compilation results in the Console view and verify that an executable has been generated in the PROJECT\Debug folder. Attachment: 5. Right click on project directory and select "Run As" --> "Application Program" Attachment: run_proj.jpg [ 72.68 KiB | Viewed 50252 times ] 6. The output will be displayed in the console view. Attachment:
|
Page 1 of 1 | All times are UTC + 8 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |