Andes Workshop
http://forum.andestech.com/

If Memory View shows "????????"
http://forum.andestech.com/viewtopic.php?f=6&t=1038
Page 1 of 1

Author:  Niraj Dengale [ Wed Aug 08, 2018 8:07 pm ]
Post subject:  If Memory View shows "????????"

If the memory View is showing "???????", it means that the addresses are unknown to GDB.
There are 2 possible cases in which this might happen
(1) There is no device, or a read error, or can not read
(2) Restricted by the memory map

For example, take a look at our default N8 memory map.
Due to not setting the region at the entered address, the memory view shows "????????"
Attachment:
Mem_view1.jpg
Mem_view1.jpg [ 196.39 KiB | Viewed 48694 times ]


Please refer to the below picture, which shows how you can add new memory regions to the default memory map.
Attachment:
Mem_view2.jpg
Mem_view2.jpg [ 212.16 KiB | Viewed 48694 times ]

Page 1 of 1 All times are UTC + 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/