Andes Workshop
http://forum.andestech.com/

AICE-MCU v1.7.7 field upgrade
http://forum.andestech.com/viewtopic.php?f=13&t=700
Page 1 of 1

Author:  cindy [ Mon May 13, 2013 2:51 pm ]
Post subject:  AICE-MCU v1.7.7 field upgrade

AICE-MCU upgrade to version 1.7.7 instructions

Step 1. Download the upgrade package and decompress it.
Attachment:
AICE-MCU_v1.7.7_20130508.zip [124.86 KiB]
Downloaded 784 times


Step 2. Connect the USB cable to your PC.
Attachment:
aice-mcu.jpg
aice-mcu.jpg [ 32.27 KiB | Viewed 8479 times ]


Double-click to execute "upgrade_aice_firmware.bat"
Attachment:
1.jpg
1.jpg [ 30.26 KiB | Viewed 8479 times ]


It needs about 3.5 minutes
Attachment:
2.jpg
2.jpg [ 37.31 KiB | Viewed 8479 times ]


Step 3. After the completion of upgrade aice firmware, please disconnect and reconnect the USB cable to reset AICE-MCU.
Attachment:
3.jpg
3.jpg [ 51.35 KiB | Viewed 8479 times ]


Step 4. Double-click to execute "upgrade_aice_fpga.bat"
Attachment:
4.jpg
4.jpg [ 24.13 KiB | Viewed 8479 times ]

It takes about 6.5 minutes.
Attachment:
5.jpg
5.jpg [ 36.47 KiB | Viewed 8479 times ]


Step 5. After the completion of upgrade aice FPGA, please disconnect and reconnect the USB cable to reset AICE-MCU.
Attachment:
6.jpg
6.jpg [ 41.2 KiB | Viewed 8479 times ]


Step 6. Verify if the upgrade was successful.
Double-click to execute "check_version.bat"
As shown below, it is version 1.7.7 now.
Attachment:
7.jpg
7.jpg [ 51.58 KiB | Viewed 8479 times ]


Step 7. If the version is not 1.7.7, please repeat steps 2-6 once.

Step 8. If the version is not 1.7.7 yet, please contact Andes Service for assistance.

----------------------------------------------------------
These devices are also required to connect R6 on the adaptor for supporting 5-wire interface.
Attachment:
r6.gif
r6.gif [ 133.15 KiB | Viewed 6029 times ]

Page 1 of 1 All times are UTC + 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/