Andes Workshop http://forum.andestech.com/ |
|
AICE-MCU v1.7.7 field upgrade http://forum.andestech.com/viewtopic.php?f=13&t=700 |
Page 1 of 1 |
Author: | cindy [ Mon May 13, 2013 2:51 pm ] |
Post subject: | AICE-MCU v1.7.7 field upgrade |
AICE-MCU upgrade to version 1.7.7 instructions Step 1. Download the upgrade package and decompress it. Attachment: Step 2. Connect the USB cable to your PC. Attachment: aice-mcu.jpg [ 32.27 KiB | Viewed 14431 times ] Double-click to execute "upgrade_aice_firmware.bat" Attachment: 1.jpg [ 30.26 KiB | Viewed 14431 times ] It needs about 3.5 minutes Attachment: 2.jpg [ 37.31 KiB | Viewed 14431 times ] Step 3. After the completion of upgrade aice firmware, please disconnect and reconnect the USB cable to reset AICE-MCU. Attachment: 3.jpg [ 51.35 KiB | Viewed 14431 times ] Step 4. Double-click to execute "upgrade_aice_fpga.bat" Attachment: 4.jpg [ 24.13 KiB | Viewed 14431 times ] It takes about 6.5 minutes. Attachment: 5.jpg [ 36.47 KiB | Viewed 14431 times ] Step 5. After the completion of upgrade aice FPGA, please disconnect and reconnect the USB cable to reset AICE-MCU. Attachment: 6.jpg [ 41.2 KiB | Viewed 14431 times ] Step 6. Verify if the upgrade was successful. Double-click to execute "check_version.bat" As shown below, it is version 1.7.7 now. Attachment: 7.jpg [ 51.58 KiB | Viewed 14431 times ] Step 7. If the version is not 1.7.7, please repeat steps 2-6 once. Step 8. If the version is not 1.7.7 yet, please contact Andes Service for assistance. ---------------------------------------------------------- These devices are also required to connect R6 on the adaptor for supporting 5-wire interface. Attachment: r6.gif [ 133.15 KiB | Viewed 11981 times ] |
Page 1 of 1 | All times are UTC + 8 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |